Afternoon all.
Does anyone happen to know the part numbers for the screws that hold the rear nappy to the chassis of the car (not to the the bumper).
A long shot but I thought I'd ask.
Cheers
Did H&S screw up _that_ badly?
Quote from: "phil4"Did H&S screw up _that_ badly?
s:lol: :lol: s:lol: I asked for that!
I know the rear splash shield number is 51406-17010, but I dont know about the screws. It might be the part listed as:
"Clip, Retainer 90467-07164",
but that could also be the push in clip that mounts the bumper to the rear crossmember... If they've got them in stock you could take a look and see if they are the parts you are after. Alternatively, they are only a course thread self tapper so you could try a hardware shop, or take a sample along to your locall Mr T and ask them if they've got any.
I take it you've lost a few of them then?
I may have a couple of spares kicking around in my kitchen that I kept from the section that was cut off my car, if I can find them you're welcome to them.
Hang on, I just re-read the message...
No need for a part number, I think from memory its a standard M5 bolt you can get them in practically any DIY store. Or if you PM me your address I'll stick a couple in the post to you on my way home, as well as a couple of M4's and M6's just to be on the safe side...
Quote from: "Comer"Quote from: "phil4"Did H&S screw up _that_ badly?
s:lol: :lol: s:lol: I asked for that!
s:lol: :lol: s:lol:
Thanks Grant I'll check those numbers out with Mr T at the weekend. Then I'll try B&Q for self tapping screws I think they are 5mm.
I left the bit cut off at H&S as that screw would have been handy. Otherwise I'll PM you next week about any spares you have.
Cheers