Started by threepot, May 30, 2022, 15:05
0 Members and 1 Guest are viewing this topic.
QuoteFronts are Mitsubishi Motors 4056A044's instead of stock MR2 (RN-UPR-4):-
Quote from: Mark A on June 17, 2022, 17:03Interesting geo setup, any experience with that set up? I'm always interested in what other people are running in the quest for handling nirvana.Mine is pretty similar Front camber -2.25 caster 2.5 toe - .03Rear camber -1.3 toe .01
Quote from: threepot on June 18, 2022, 10:17Is that toe in/out really in mm's? Where is it measured from?
Quote from: threepot on June 18, 2022, 11:50How do you work that out? Where do you measure this 1mm? Or do you measure in degrees?When I do some basic Trigonometry on a 15" - 381mm wheel, I cannot get anything line this conversion factor, I get 1mm = 0.3 degrees.Educate me
Quote from: Chilli Girl on June 24, 2022, 20:01Your doing brilliantly with this - really well done, it's good to see it all coming together.
Quote from: threepot on June 29, 2022, 14:10Project Horrific strikes again!!Been out for a drive about this morning, another shake down.Turned it off, then it wouldn't restart. Cranks over mega slow.It did this last week outside a mates house. This time though it wouldn't start.Got 2 girls to give it a push and it started OK. Brought it back home, wouldn't start again. Went for a brew for 15 mins, then it would start again.Voltages are good, charging/alternator is good. No voltage drops over the cables or ground straps etc.Pretty sure the starter is getting stiff/draggy when its hot, or 1 of the 4 brushes inside isn't contacting.Best get this starter motor dropped off the car tonight and strip it down.