Print Page - PRE CAT GASKET REF NUMBERs????

Title: PRE CAT GASKET REF NUMBERs????
Post by: Anonymous on March 7, 2006, 12:56

Does anyone know what the ref numbers are for the 2 gaskets I will need to replace when I get the Pre-cats done on my car?

Thanks

Title:
Post by: edward.carter on March 7, 2006, 13:01

m http://www.mr2roc.org/phpBB2/viewtopic. ... c&start=25 (http://www.mr2roc.org/phpBB2/viewtopic.php?t=3507&postdays=0&postorder=asc&start=25) m

very bottom of page.

Title:
Post by: Anonymous on March 7, 2006, 13:13

Superb

Thanks very much

Title:
Post by: edward.carter on March 7, 2006, 13:14

you might want the manifold gasket too, not sure of the part number but toyota parts desk be able to find it for you. there not essential but worth it for a few quid

Title:
Post by: Anonymous on March 7, 2006, 14:42

I think it is T90917-06065.

Title:
Post by: Anonymous on March 7, 2006, 14:49

thanks

does anyone know the other gasket number as I think there are 2 or are they the same gasket on both ends?

Title:
Post by: kanujunkie on March 7, 2006, 15:18

only gaskets you need are the 2 gaskets between the header and the cat as posted in the link above

Title:
Post by: Anonymous on March 7, 2006, 15:19

Cheers Stu

Title:
Post by: kanujunkie on March 7, 2006, 15:20

just for ref, the block to header one is a flat plate/shim style seal and can be re-used

Title:
Post by: Anonymous on March 7, 2006, 15:34

So I only need one new gasket Stu?

Title:
Post by: kanujunkie on March 7, 2006, 15:39

Quote from: "daz8365"So I only need one new gasket Stu?

no 2, the 2 round ones between the header and cat as pictured and listed in the link

Title:
Post by: Anonymous on March 9, 2006, 13:12

Is it worth ordering a set of bolts / studs in case of the dreaded shear? Surely these can't be too expensive and would ensure the car is off the road for the least amount of time as. i.e. not requiring a further parts order and a trip to Mr T because of a rounded / snapped. Part numbers?

Has anyone replaced them with stainless studs / bolts?

Title:
Post by: Anonymous on March 9, 2006, 13:31

Quote from: "ShaunyF"Has anyone replaced them with stainless studs / bolts?

http://www.mr2roc.org/phpBB2/viewtopic.php?t=3507&start=200

Last few replies on this page....

MR2 Roadster Owners Club

The Workshop => Maintenance, Problems & Troubleshooting => Topic started by: Anonymous on March 7, 2006, 12:56