Think Iv done it wrong lost on what to do next ?(http://img.tapatalk.com/d/13/08/09/8uga5u3y.jpg)(http://img.tapatalk.com/d/13/08/09/ahasa5a4.jpg)
Rip out the white plastic speaker plug socket from the grey speaker mount leaving a hole that you can feed the speaker wire through. Cut off the white plastic plug from the speakers and fit some spade connectors that will slide onto your new speaker connections.
If you look at my post here on the last page I've put which wire is + and - s:) :) s:)
Re: Fitting New front speakers !!!!! All explained
l viewtopic.php?t=144#p440729 (http://www.mr2roc.org/phpBB3/viewtopic.php?t=144#p440729) l
AckersMR2 ur a life saver!! How did u get the white plug socket out? im struggling :-/
Just cut the wires the put crimp connectors on or even better solder them direct to the terminals on the speakers
Il have get some spade connectors, I'm bloody lost saw this (http://img.tapatalk.com/d/13/08/09/bu2yju2e.jpg)
And haven't a clue!
Quote from: "amz91"AckersMR2 your a life saver!! How did u get the white plug socket out? I'm struggling :-/
If I recall just brute force and ignorance s;-) ;-) s;-)
Quote from: "AckersMR2"Quote from: "amz91"AckersMR2 your a life saver!! How did u get the white plug socket out? I'm struggling :-/
If I recall just brute force and ignorance s;-) ;-) s;-)
Like this ? Haha (http://img.tapatalk.com/d/13/08/09/rasapupe.jpg)
Haha I just got some big wire cutters and twisted it off.
That looks like the cable that goes from the tweeter to the crossover or if you don't have separate crossovers then to the main speaker. Try dropping a PM to Stargazer30 as I think he has installed a set of those in the past?
Quote from: "amz91"Like this ? Haha
Yep looks just like mine s:lol: :lol: s:lol:
Check the depth of your new speakers, if there's plenty of room between the back of the speaker and the door skin then rip off that cardboard and foam from the plastic mount, otherwise the front of the speaker rim might touch the door card. If I recall I ripped it off.
Quote from: "amz91"Il have get some spade connectors, I'm bloody lost saw this (http://img.tapatalk.com/d/13/08/09/bu2yju2e.jpg)
And haven't a clue!
Connect the spade ends to your speakers and the wire ends to the Toyota speaker wire in the door. If you look in the box you might find a wiring diagram, if not look here s;-) ;-) s;-)
m http://edgecaraudio.co.uk/manuals/ed3_c ... manual.pdf (http://edgecaraudio.co.uk/manuals/ed3_component_speaker_manual.pdf) m
Quote from: "AckersMR2"Check the depth of your new speakers, if there's plenty of room between the back of the speaker and the door skin then rip off that cardboard and foam from the plastic mount, otherwise the front of the speaker rim might touch the door card. If I recall I ripped it off.
Your joking I ripped this off by mistake then thought s*** that wasn't suppose happen and stuck it bk on! Haha s:-D :-D s:-D
Make sure you flash tape the doors it makes a massive difference
Thank you both, will do this either 2mora or Saturday.
I don't know what I'd do without this forum!
Iv pm'd stargazer30 :-) :-) :-)