“Roadster” badge location on the rear lid

Started by rajid, April 18, 2026, 22:27

0 Members and 1 Guest are viewing this topic.

rajid

Want to replace this on my car as it was missing when I picked it up.
Have a new badge now waiting to go on!

Does anyone have the correct measurements and notes as to where exactly it's stuck on?

It has the Toyota badge on the left of the lid

MR2 in the top centre of the bumper

And no badge on the right of the lid

If anyone's car has it in the original spot, would appreciate the measurements or some way to template where it's attached.

Thank you all!

rajid

bouncing this one to the top!

surely everyone else has this badge except for me? lol

help!

Craigjm

I don't have any badges on mine so I can't help sorry

Joesson

This is the best I can offer as I no longer have my 2:



Ardent

#4
must have been removed a long ago if no residual marking on the paint.

Have a look in the what have you done posts or photography corner will be a pic or two of mine for reference.

rear end


fawtytoo

Quote from: Ardent on April 24, 2026, 22:29must have been removed a long ago if no residual marking on the paint.
Or repainted?

I'm going to respray the top half of my bumper and looks like I'm going to have to remove the badges. I've taken photos of their current positions in case I decide to refit them.




Life Driving is about the journey, not the destination.
"My name is not important" - Slartibartfast

ruud2boy

#6
Would correct positioning be that important? You're going to get it within a cm just by eye, surely.
I took the Toyota and Roadster badges off mine, just leaving the MR2 in the middle. In my mind, it's not a Toyota and definitely not a 'Roadster' - it's just an MR2. Anybody that knows what these cars are will know, and anyone that doesn't - well, meh.......

Just looking at the residual 'shadow' on mine - which I've tried & better tried to get rid of - the top-right corner of the R at the end of roadster is 350mm from the edge of the engine cover, and the bottom right of the R is 50mm above the swage line.